Tweet
Hello there!
I have a strange problem. I assembled my new PC with the following configurations:
GA-EP31-DS3L rev. 1.0
Core 2 duo E6300
1GB DDR2 RAM Buffalo select 800Mhz
ATI HD3450
SATA 160GB maxtor
PSU LC POWER LC6600GP
But that doesnt really matter because I have the following problem:
I connected the ATX 12V cable, the 12pin ATX cable, my CPU has a cooler installed and pluged in and I have disconected all hardware, took out RAM moduls, everything - First i tried with hardware put in, but then took it out one by one.
What my mobo does is: when I switch the button on my PSU to 1 (power on) and then aprox. after 1 second all 4 phase LED`s flash for about a fraction of a second and a strange noise appears (like a klick) - i think it comes from my PSU but not sure. Then when i try to start the PC I cannot even get it to start up with the power button on my tower.
The PSU works fine, because I have tested it on 2 other computers and its not a lowlife PSU either (but its not highend either). The CPU was taken from another PC, so it should also work fine.
I have searched the web for the meaning of this short phase LED`s flashing but found no answer. If someone could point me the way I would appreciate it very much.
Erik
I have a strange problem. I assembled my new PC with the following configurations:
GA-EP31-DS3L rev. 1.0
Core 2 duo E6300
1GB DDR2 RAM Buffalo select 800Mhz
ATI HD3450
SATA 160GB maxtor
PSU LC POWER LC6600GP
But that doesnt really matter because I have the following problem:
I connected the ATX 12V cable, the 12pin ATX cable, my CPU has a cooler installed and pluged in and I have disconected all hardware, took out RAM moduls, everything - First i tried with hardware put in, but then took it out one by one.
What my mobo does is: when I switch the button on my PSU to 1 (power on) and then aprox. after 1 second all 4 phase LED`s flash for about a fraction of a second and a strange noise appears (like a klick) - i think it comes from my PSU but not sure. Then when i try to start the PC I cannot even get it to start up with the power button on my tower.
The PSU works fine, because I have tested it on 2 other computers and its not a lowlife PSU either (but its not highend either). The CPU was taken from another PC, so it should also work fine.
I have searched the web for the meaning of this short phase LED`s flashing but found no answer. If someone could point me the way I would appreciate it very much.
Erik
Comment